Cooper-pair qubit and Cooper-pair electrometer in one device

An all-superconductor charge qubit enabling a radio-frequency readout of its quantum state is described. The core element of the setup is a superconducting loop which includes the single-Cooper-pair (Bloch) transistor. This circuit has two functions: First, it operates as a charge qubit with magnetic control of Josephson coupling and electrostatic control of the charge on the transistor island. Secondly, it acts as the transducer of the rf electrometer, which probes the qubit state by measuring the Josephson inductance of the transistor. The evaluation of the basic parameters of this device shows its superiority over the rf-SET-based qubit setup.Comment: 4 pages incl. 3 figues; the SQUID'2001 paper, to be published in Physica

Subgap conductivity in SIN-junctions of high barrier transparency

We investigate the current-voltage characteristics of high-transparency superconductor-insulator-normal metal (SIN) junctions with the specific tunnel resistance below 30 kOhm per square micron. The junctions were fabricated from different superconducting and normal conducting materials, including Nb, Al, AuPd and Cu. The subgap leakage currents were found to be appreciably larger than those given by the standard tunnelling model. We explain our results using the model of two-electron tunnelling in the coherent diffusive transport regime. We demonstrate that even in the high-transparency SIN-junctions, a noticeable reduction of the subgap current can be achieved by splitting a junction into several submicron sub-junctions. These structures can be used as nonlinear low-noise shunts in Rapid-Single-Flux-Quantum (RSFQ) circuitry for controlling Josephson qubits.Comment: 6 pages, 5 figures, 1 tabl

Decoherence in circuits of small Josephson junctions

We discuss dephasing by the dissipative electromagnetic environment and by measurement in circuits consisting of small Josephson junctions. We present quantitative estimates and determine in which case the circuit might qualify as a quantum bit. Specifically, we analyse a three junction Cooper pair pump and propose a measurement to determine the decoherence time $\tau_\phi$.Comment: 4 pages, 4 figure

Comparison of Coulomb Blockade Thermometers with the International Temperature Scale PLTS-2000

The operation of the primary Coulomb blockade thermometer (CBT) is based on a measurement of bias voltage dependent conductance of arrays of tunnel junctions between normal metal electrodes. Here we report on a comparison of a CBT with a high accuracy realization of the PLTS-2000 temperature scale in the range from 0.008 K to 0.65 K. An overall agreement of about 1% was found for temperatures above 0.25 K. For lower temperatures increasing differences are caused by thermalization problems which are accounted for by numerical calculations based on electron-phonon decoupling.Comment: 6 pages, 5 figure

Transport and Noise Properties of sub-100-nm Planar Nb Josephson Junctions with Metallic Hf-Ti Barriers for nano-SQUID Applications

We analyze electric transport and noise properties at 4.2 K of self-shunted superconductor-normal metal-superconductor (SNS) sandwich-type Josephson junctions, comprising Nb as the superconductor and Hf-Ti as the normal conducting material, with lateral dimensions down to approximately 80 nm. The junctions are fabricated with an optimized multilayer Nb technology based on nanopatterning by electron-beam lithography and chemical-mechanical polishing. The dependence of transport properties on the junction geometry (lateral size and barrier thickness d(Hf-Ti)) is studied, yielding a characteristic voltage V-c up to approximately 100 mu V for the smallest d(Hf-Ti) = 17 nm. The observed small hysteresis in the current-voltage curves of devices with high V-c and large size can be attributed to self-heating of the junctions and fitted with an extended version of the resistively shunted junction model. Measurements of voltage noise of single junctions are consistent with the model including self-heating effects. The potential of our technology for further miniaturization of nanoscale superconducting quantum interference devices and for the improvement of their performance is discussed

Coulomb Blockade in low mobility nanometer size Si:MOSFETs

We investigate coherent transport in Si:MOSFETs with nominal gate lengths 50 to 100nm and various widths at very low temperature. Independent of the geometry, localized states appear when G=e^{2}/h and transport is dominated by resonant tunnelling through a single quantum dot formed by an impurity potential. We find that the typical size of the relevant impurity quantum dot is comparable to the channel length and that the periodicity of the observed Coulomb blockade oscillations is roughly inversely proportional to the channel length. The spectrum of resonances and the nonlinear I-V curves allow to measure the charging energy and the mean level energy spacing for electrons in the localized state. Furthermore, we find that in the dielectric regime, the variance var(lng) of the logarithmic conductance lng is proportional to its average value consistent with one-electron scaling models.Comment: 4 pages, 4 figure

Quantum Effects in Small-Capacitance Single Josephson Junctions

We have measured the current-voltage (I-V) characteristics of small-capacitance single Josephson junctions at low temperatures (T=0.02-0.6 K), where the strength of the coupling between the single junction and the electromagnetic environment was controlled with one-dimensional arrays of dc SQUIDs. The single-junction I-V curve is sensitive to the impedance of the environment, which can be tuned IN SITU. We have observed Coulomb blockade of Cooper-pair tunneling and even a region of negative differential resistance, when the zero-bias resistance R_0' of the SQUID arrays is much higher than the quantum resistance R_K = h/e^2 = 26 kohm. The negative differential resistance is evidence of coherent single-Cooper-pair tunneling within the theory of current-biased single Josephson junctions. Based on the theory, we have calculated the I-V curves numerically in order to compare with the experimental ones at R_0' >> R_K. The numerical calculation agrees with the experiments qualitatively. We also discuss the R_0' dependence of the single-Josephson-junction I-V curve in terms of the superconductor-insulator transition driven by changing the coupling to the environment.Comment: 11 pages with 14 embedded figures, RevTeX4, final versio

Electronic and thermal sequential transport in metallic and superconducting two-junction arrays

The description of transport phenomena in devices consisting of arrays of tunnel junctions, and the experimental confirmation of these predictions is one of the great successes of mesoscopic physics. The aim of this paper is to give a self-consistent review of sequential transport processes in such devices, based on the so-called "orthodox" model. We calculate numerically the current-voltage (I-V) curves, the conductance versus bias voltage (G-V) curves, and the associated thermal transport in symmetric and asymmetric two-junction arrays such as Coulomb-blockade thermometers (CBTs), superconducting-insulator-normal-insulator-superconducting (SINIS) structures, and superconducting single-electron transistors (SETs). We investigate the behavior of these systems at the singularity-matching bias points, the dependence of microrefrigeration effects on the charging energy of the island, and the effect of a finite superconducting gap on Coulomb-blockade thermometry.Comment: 23 pages, 12 figures; Berlin (ISBN: 978-3-642-12069-5

Proximity Induced Josephson-Quasiparticle Process in a Single Electron Transistor

We have performed the first experiments in a superconductor - normal metal - superconductor single electron transistor in which there is an extra superconducting strip partially overlapping the normal metal island in good metal-to-metal contact. Superconducting proximity effect gives rise to current peaks at voltages below the quasiparticle threshold. We interpret these peaks in terms of the Josephson-quasiparticle process and discuss their connection with the proximity induced energy gap in the normal metal island.Comment: 4 pages + 4 figure

Communicating Josephson Qubits

We propose a scheme to implement a quantum information transfer protocol with a superconducting circuit and Josephson charge qubits. The information exchange is mediated by an L-C resonator used as a data bus. The main decoherence sources are analyzed in detail.Comment: 4 pages, 2 figure